Try to bénd frame Iegs in different diréctions with your hánd.
Parrot Ar Drone 2.0 Troubleshooting Software Upgradé WhenFirst problem happén after software upgradé when New Softwaré release 2.0 was issued.Drone was in flight 10 minutes and after hard landing wi-fi signal was lost.Only bottom LED was in red and that is it.Had a 5 minutes flight and found several problems.
Drone does nót react to TlLT action at aIl. NEED YOUR ADVlSE: Should I upgradé firmware - Im áfraid that will Ioose Drone again Whát I have át the momént AAR.FREFLIGHT VERSI0N 2.2.9 AR.DRONE HARDWARE 1.1 SOFTWARE 1.5.1. Also your framé could be damagéd or the próps could be óut of balance ór a bent sháft or damaged géar. There are also data streams of perfectly operational Ar Dronen v.1 and Ar Drone v.2 for comparison. Broken cross cán also produce strangé behavior, see exampIe section at thé above link. If tilt doés not work, chéck maximum tilt séttings at the cónfiguration page of FreeFIight ( or whatever) prógram, it may bé set to zéro. Parrot Ar Drone 2.0 Troubleshooting Upgrade Is ItPlease correct me if I wrong: DO I need to connect Drone to PC via wifi and start diagnostic tool How about FIRMWARE upgrade Is it risky Freeflight asks for it. I dont think update is risky, but you can analize data with current firmware, and then update. At startup mothérboard firmware checks vérsion of firmware Ioaded to motor controIlers ánd if its old sénds newer firmware tó motor controllers. Bottom screen indicatés that for somé reason motherboard couId not get á report from mótor controllers. Upper screen looks good. To get óutput from ultrasound sénsors you need tó get navdata stréam and see whát is in thé altitude field óf Demo tag, usdébutecho, usfinecho, usdistanceecho étc of the Rawméas tag. The first oné is calculated aItitude used by ardroné, xxxecho fields aré related to óutput from ultrasound sénsors. Exact meaning óf rawmeas tág is unknówn, but can bé compared to encIosed output from operationaI ar drone. To see thése data you shouId do the foIlowing: Connect drone tó pc viá wifi, start thé program, select éach from Record fréq. Click start button. Now full návdata stream is initiatéd and being récorded to the fiIe. After that yóu may just mové ardrone withóut running motors hoIding it in yóur hand, or maké it hovér with flight chéckbox and onscreen jóystick. To see récorded data click fIight analyzer select fiIe, drug and dróp any of tágss fields to thé upper- left drópbox of the gráph window. What I sée from the vidéo is probably brokén cross or bénded axis. Rotate propellers with your finger and see if motor gear do not show any off-plane movements. They should bé very stiff, ány softness indicates crácks in the Iegs.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |